To Next PageTo Next Page
Need help?Do you have a question about the Azbil SDC45 and is the answer not in the manual?
General| Brand | Azbil |
|---|---|
| Model | SDC45 |
| Category | Controller |
| Language | English |
Details the physical components of the SDC45 and SDC46 controllers.
Explains how to use the controller's buttons for setting parameters and navigating menus.
Configures operational modes like READY, AUTO/MANUAL, and RSP.
Sets PID control parameters for Loop 1, including Proportional band, Integral, and Derivative times.
Sets PID control parameters for Loop 2, including Proportional band, Integral, and Derivative times.
Defines SP ramp settings, tracking, and digital RSP configuration.
Configures event settings, including operation types, delays, and hysteresis.
Sets control action, algorithm, ranges, and initialization for PID control.
Configures output behavior at READY, PV alarm, and fixed value outputs.
Defines system settings like loop type, backup type, and display customization.
Configures PV input range types, decimal points, units, and compensation.
Sets output ranges, types, scaling limits, and linearization for various outputs.
Configures internal contact input settings like operation type, input type, and weight.
Sets digital output types, latching behavior, and event assignments.
Configures logical operations based on input assignments and polarity.
Defines mathematical/logical operations and contact inputs for computation.
Configures multi-status displays, conditions, decimal points, and F key assignments.
Configures RS-485 communication settings like protocol, address, and speed.
Manages lock levels for setting changes, display access, and communication.
Displays various status, PV, MV, alarm, input, and output information.
Shows firmware information, manufacturing dates, and serial numbers.
Defines SP group selection for Loop 1 and Loop 2.
Configures multiple SP values and PID group definitions for Loop 1.
Configures multiple SP values and PID group definitions for Loop 2.
Sets event main/sub settings, PID parameters, and output limits for Loop 1 recipes.
Sets event parameters, PID settings, and output limits for Loop 2 recipes.
Configures Remote Setpoint (RSP) settings and PID group definitions.
Defines event main and sub settings for control actions.
Lists standard bit codes (1024-2047) for various functions and statuses.
Lists standard numerical codes (2048-3071) for various functions and statuses.
