Azbil BH-101G0W0000 - System Configuration

4
AB-7333
 System Conguration
Third-party
BACnet/IP
device
Third-party
BACnet/IP
device
Operator
Interface
*7
Model
QJ-1101
Third-party
BACnet/IP
device
ETHERNET
*5
Infilex VC
Model
WY5706
Model
MY804_A
Model
FVY516_J00__
Damper
Actuator
SAnet
*3
Model WJ -110 2
Operator Panel
(Panel Mount
Type)
*4
Model
QY5100W0000
Model QY7205
Neopanel
*4
Direct Mount
I/O Module
SAnet I/F Module
Setting-Device
Connection Module (SD)
Model RY51_ _
Supervisory
device network
Primary device
network
Secondary device
network
General
Controller
Third-party
Modbus/
TCP device
Third-party
Modbus
device
Compact
Remote
I/O Module
Third-party
BACnet
MS/TP
device
Advanced
Remote
I/O module
Advanced
Remote
I/O module
Advanced
Remote
I/O module
Model
RJ-11_ _
Model
RJ-11_ _
Model
WJ-1111
Remote
I/O network
*6
Model
RJ-11_ _
Model RJ-12_ _
Compact
Remote
I/O Module
Model RJ-12_ _
Switching hub
*1
Switching hub
Switching hub Switching hub
Switching hub Switching hub
RS-485
*3
(if BACnet MS/TP is selected)
Third-party
BACnet
MS/TP
device
FCU
Controller
Model
WJ-1202
RS-485
*2
(if BACnet MS/TP is selected)
ACTIVAL +

RS-485
*2
(if Modbus is selected)
RS-485
*2
(if Modbus is selected)
ETHERNET (BACnet/IP, Modbus/TCP, etc.).
The communication distance between each device and the switching hub must be 100 m or less.
Advanced
Controller for
Chiller/Pump Units
Supervisory Controller
Model BH-101G
Client PC
Network Attached
Storage
Third-party
Modbus
device
Supervisory Controller
Model BH-101G
(Active)
Supervisory Controller
Model BH-101G
(Standby)
(Redundancy)
Switching hub
*1
Switching hub
*1
Network Attached
Storage
Figure 1. Example system conguration