◇ Model Numbers
D04 Filter-Regulator,
or D14 Regulator
Oil Drip Monitor
or
Oil Feed Monitor
Models w/o
Electrical Control
Circuit
Models w/
Electrical Control
Circuit
Note:
1. Pressure gauge for operating pressure is attached on the MC9 models equipped with
D04 (Filter-Regulator integrated solenoid valve), and on the MC9 models equipped with
D14 (Regulator integrated solenoid valve).
2. Manifold pressure gauge and oil level switch are standard equipped items.
3.
・Twin timer or programmable controller should be prepared in advance separately
for the interval oil shot operation of the pump in the Micron-Lub lubrication unit.
(MC9 models with electrical control circuit are excepted)
・User side must make electrical control circuit for the Micron-Lub lubrication system.
4. Filter-Regulator with solenoid valve have no function to remove moisture and gaseous oil
contained in supply air. (This is 3:-:- of compressed air quality classification). Installations of air
preparation equipment that satisfy the Micron-Lub lubrication system are required. We Azbil TA
are dealing in oil removal filters removing gaseous oil, which are recommended to install in air
supply side, for the compressed air quality classification of 1. - 2.
To Next Page
Loading...
Need help?
General
