Azbil SDC35 - Page 125

5-65
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION

Operation type
The operation type of the internal event can be set.
Item (Bank) Display Contents Initial value User level
Internal Event 1
Configuration 1
(Event Configuration bank)
0: No event
1: PV high limit
2: PV low limit
3: PV high/low limit
4: Deviation high limit
5: Deviation low limit
6: Deviation high/low limit
7: Deviation high limit
(Final SP reference)
8: Deviation low limit
(Final SP reference)
9: Deviation high/low limit
(Final SP reference)
10: SP high limit
11: SP low limit
12: SP high/low limit
13: MV high limit
14: MV low limit
15: MV high/low limit
16: CT1 heater burnout/over-current
17: CT1 heater short-circuit
18: CT2 heater burnout/over-current
19: CT2 heater short-circuit
20: Loop diagnosis 1
21: Loop diagnosis 2
22: Loop diagnosis 3
23: Alarm (status)
24: READY (status)
25: MANUAL (status)
26: RSP (status)
27: During AT execution (status)
28: During SP ramp (status)
29: Control direct action (status)
30: ST setting standby (status)
(Invalid in this unit.)
31: During estimated position control
(status)
32: Timer (status)
33: High and Low limits of MFB value
(Invalid in this unit)
0 Basic,
Standard,
High function
Internal Event 2
Configuration 1
(Event Configuration bank)
0
Internal Event 3
Configuration 1
(Event Configuration bank)
0
Internal Event 4
Configuration 1
(Event Configuration bank)
0
Internal Event 5
Configuration 1
(Event Configuration bank)
0
Internal Event 6
Configuration 1
(Event Configuration bank)
0
Internal Event 7
Configuration 1
(Event Configuration bank)
0
Internal Event 8
Configuration 1
(Event Configuration bank)
0
Handling Precautions
• If ROM version 1 of the instrument information bank (
I

d02
) is prior to
2.04, “33” cannot be set as [Internal Event configuration 1 operation type].