1-6
Chapter 1. OVERVIEW
Mode indicators
[man]: AUTO/MANUAL mode indicator. Lights in MANUAL
mode.
[rsp]: LSP/RSP mode indicator. Lights in RSP mode.
[ev1], [ev2], [ev3]: Event output 1 to 3 indicator. Lights when event relays are
ON.
[ot1], [ot2]: Control output 1 and 2 indicator. Lights when the control
output is ON. The indicators are always lit when the current
output or continuous voltage output is used.
Multi-Status (MS) display
By combining the lighting conditions with the lighting status, three groups can be
set for priority display.
For lighting conditions, the internal event ON status, DI ON status, and READY
mode are provided.
For lighting status, flashing, reciprocating between left and right, and MV graph
are provided.
Jack cover: This jack cover protects the loader connector. When
connecting the loader, pull this cover upward by finger.
Loader connector: This connector is used for connecting to a personal computer
using the dedicated cable supplied with the Smart Loader
Package.
Handling Precautions
• To select the LSP group using the [mode] key, it is necessary to set a value
of “2” or more in [LSP system group].
• To show the RUN/READY mode and communication status using the
decimal point at the right end digit on the lower display, select “High
function configuration” and make the [LED monitor] settings.
• Do not operate the key with a sharp object (such as tip of mechanical
pencil or needle). Doing so might cause the unit to malfunction.
• If the jack cover is pulled forcibly, it may be broken. Never attempt to pull
this cover forcibly.
To Next Page
Loading...
