2-6
Chapter 2. OUTLINE OF FUNCTIONS
(3) Release the key and wait for a while.
>> After 2 s have elapsed, the flashing display is stopped, and then the data you
have changed is set.
pv
sp
pv
sp
Handling Precautions
• If the data does not start flashing even though the [enter] key is pressed
(for a standard type) or the [<], [
], or [
] key is pressed (for a special
type), this data cannot be changed.
For example, when the RUN/READY is assigned in the DI Assignment,
RUN/READY cannot be selected using the key on the front panel.
• If the character string cannot be changed using the [
] key while the
entire character string is flashing, press the [
] key.
On the contrary, if the character string cannot be changed using the [
]
key, press the [
] key.
• When pressing the [para] key while the display is flashing on the bank
setup display or user function setup display, the next data is displayed
without changing of the data. Additionally, when pressing the [display]
or [mode] key while the display is flashing, the display returns to the
operation display without changing of the data.
• When pressing the [display] key while the display is flashing on the
operation display, the next data is displayed without changing of the
data.
• The MV (manipulated variable) display in the MANUAL mode continues
the flashing status even after pressing of the key has been stopped. At
this time, the flashing value is output as MV.
To Next Page
Loading...
