5.4. KEYBIND SETUP
When pressing button on the device, the corresponding button will light
up in the Azeron software.
To setup buttons, with your mouse click on the button you wish to setup,
then on the right side panel choose between several modes.
At the top you can name the
button by writing custom
label, for example, “Jump”.
It is possible to setup several
modes on one button at the
same time – single click, long
press and double press.
If you choose all three modes,
then the corresponding
symbols will appear on top of
the button:
Single click keybind will
execute immediately on
button press. Long press
keybind will execute only
after the delay that you
specify while holding down
the button. Double press
keybind will execute after the
button is pressed 2 times.
If you are using Single click and Long press modes on the same button, then there may
be a small lag for Single click keybind. The shorter the Long press delay is specified,
the shorter will be the lag on Single click keybind. If you specify very short delay, then
there is a chance that Long press will be executed unintentionally, when you actually
expect to have Single click keybind executed.
To Next Page
Loading...