User Manual
Page 24 of 88
2. You may enable or disable IGMP Snooping and its required
properties if it is required in your network. It is highly suggested
to enable this if you wish to filter out multicast traffic in your
network.
3. If you wish to enable or disable firewall filters specified in the
Firewall Configuration, tick the Enable LAN Side Firewall.
4. If you wish to implement Static IP addressing, tick Disable DHCP
Server.
NOTE: By default, DHCP Server is enabled.
5. For Dynamic IP Addressing (DHCP) tick Enable and enter the
Start IP and End IP Address, the correct subnet mask, and the
lease time (in hours) for all connected devices.
6. If you wish to indicate a second IP address for your router, tick
the Configure the second IP Address and Subnet Mask for LAN
interface and define the values needed in the fields. This may
come in handy when you are troubleshooting your router.
7. Click the Save/Reboot button to apply all changes.
Static IP Lease List. Displays the statically assigned IP addresses in
the network, each device’s MAC Address and assigned IP
Address can be seen in this table. It also allows you to remove
reserved IP addresses as well.
To Next Page
Loading...
Need help?
General
