User Manual
Page 55 of 88
NOTE: You may have to search for your application’s
corresponding port ranges.
f. Enter the Open Port Start and Open Port End values and
determine the Open Protocol to be implemented.
NOTE: You may have to search for your application’s
corresponding port ranges.
g. Click Save/Apply button to apply changes.
To remove a port trigger:
a. Tick the corresponding checkbox of the application.
b. Click Remove to remove the port triggered application.
DMZ Host. Allows you to assign a computer as a DMZ Host. It will
then receive all the data from the Internet that does not belong
to the list of applications configured in Port Forwarding.
To configure the DMZ host:
a. Enter the LAN IP address of the PC you wish to set as DMZ
Host in the DMZ Host IP Address.
b. Click the Save/Apply button to apply changes.
To Next Page
Loading...
