User Manual
Page 15
of 46
Using a DSL or Cable Modem
If you choose to use a DSL or Cable modem you are required to have the following:
DSL or cable modem
Active Internet Account
1. Connect your DSL or Cable modem to the router’s WAN port using an Ethernet cable.
2. Connect the power cable to the router’s power jack and plug it in to the wall socket.
3. Connect your PC to any of available Ethernet port using an Ethernet cable or connect via wireless.
Note:
Note:Note:
Note: Ensure that the router’s IP address does not conflict with the DSL/Cable modem. Please refer to your
modem’s User Manual on how to change the LAN IP address.
Connecting to the Internet
To Connect to the Internet via the Web User Interface:
1. Open your Internet web browser.
2. Type http://192.168.2.1 in the address bar and press enter. This opens the login authentication page.
3. Type your Username and Password. Your default Username and Password is admin/admin.
4. Click the Wizard Tab then Follow the step-by-step guide on how to setup the router.
To Next Page
Loading...
Need help?
General
