User Manual
Page 37
of 46
Advanced Page
Network
Local
This section allows you to configure your local network connection.
• Router IP Address – this is the router’s default gateway. Use this IP address to access the router’s
Web GUI by enter IP address on the Internet explorer bar.
•
Router Subnet Mask – this is the router’s subnet mask.
•
DHCP Enabled- Your HW550-3G has a built in DHCP server. Your HW550-3G will automatically
assign an IP address to all the computers that will connect to your network. Check the TCP/IP
settings of your computer and make sure to set it on “Obtain an IP automatically”. Note that when
you uncheck the button it will disable the DHCP server. You need to have another DHCP server or
you need manually set the IP address of the computer when your DHCP is disabled.
• Start IP Address- This field specifies the first of the IP addresses in the IP address pool.
• End IP Address- This field specifies the last of the IP addresses in the IP address pool.
• Subnet Mask- Enter the Subnet Mask provides by your ISP.
• Primary DNS Server- Enter the Primary DNS server IP address provides by your ISP.
• Secondary DNS Server- Enter the Secondary DNS server IP address provides by your ISP.
• Default Gateway- Recommend to use the router’s LAN port IP address.
• Lease Time (sec)- this is the amount of time in which the user is allowed to use the current
dynamic IP address.
To Next Page
Loading...
Need help?
General
