User Manual
Page 19
of 46
WPS (Wi-Fi Protected Setup)
WPS button allows you to activate Wi-Fi Protected Setup (WPS). When you press the WPS button it
automatically detects and connects wireless clients into the wireless network by broadcasting the wireless
network settings from your Access Point to you wireless device/s.
To setup WPS:
1. Press the WPS button on the router for two seconds, or until the LED blinks
2. Within 3 minutes, press the WPS button on the Wireless Client.
Note:
Note:Note:
Note: WPS can only be used with wireless client devices that have a compatible WPS component.
Connect/Disconnect Button
Connect/Disconnect button allows you to connect/disconnect to the Internet using your 3.5G mobile
broadband.
To Setup Connect/Disconnect Button:
1. Press the Connect/Disconnect button for 2 seconds to change the current status of your 3.5G
mobile broadband Internet connection.
Note:
Note:Note:
Note: This button only applies for UMTS 3.5G Internet Connection type.
To Next Page
Loading...
Need help?
General
