146
EMBROIDERY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Connecting character patterns
If the character pattern is too long to fit in the
embroidery frame, follow the steps below.
Example: Connecting "ABC" with "DEF"
a
Enter "ABC" and press .
b
Press to turn off the automatic thread
cutting ( ).
c
Press (Back key).
d
Press .
e
Press .
f
Press to turn it to .
X The stitching starting point is set to lower left
of the design.
g
Lower the presser foot, and then press
(Start/stop switch) to begin sewing.
h
When embroidering is finished, trim the thread
leaving the end of the thread longer than
usual. Then reset the fabric in the embroidery
frame, in a position where you can sew "DEF".
a Embroidery start position
b Embroidery end position
i
Enter "DEF" and press .
j
Press .
k
Press to turn it to .
X The stitching starting point is set to lower left
of the design.
a
b
0711-0120-C-combo_E.book Page 146 Tuesday, August 26, 2008 2:43 PM
To Next Page
Loading...
