30
GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
f
Pull out about 10-15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
g
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
a Tab
b Lower-left corner
1
2
a
b
0711-0120-C-combo_E.book Page 30 Tuesday, August 26, 2008 2:43 PM
To Next Page
Loading...
