Care and Maintenance
A-2
Restrictions on oiling
In order to prevent damaging this machine, it must not be
oiled by the user.
This machine was manufactured with the necessary amount
of oil applied to ensure correct operation, making periodic
oiling unnecessary.
If problems occur, such as difficulty turning the handwheel or
an unusual noise, immediately stop using the machine, and
contact your authorized Baby Lock retailer.
Precautions on storing the machine
Do not store the machine in any of the locations described
below, otherwise damage to the machine may result, for
example, rust caused by condensation.
• Exposed to extremely high temperatures
• Exposed to extremely low temperatures
• Exposed to extreme temperature changes
• Exposed to high humidity or steam
• Near a flame, heater or air conditioner
• Outdoor or exposed to direct sunlight
• Exposed to extremely dusty or oily environments
Cleaning the LCD screen
If the screen is dirty, gently wipe it with a soft, dry cloth. Do
not use organic solvents or detergents.
Cleaning the machine surface
If the surface of the machine is dirty, lightly soak a cloth in
neutral detergent, squeeze it out firmly, and then wipe the
surface of the machine. After cleaning it once with a damp
cloth, wipe it again with a dry cloth.
Cleaning the race
Sewing performance will suffer if lint and dust collects in the
bobbin case, therefore, it should be cleaned regularly.
a
Press (Needle position button) to raise the needle.
b
Turn off the machine.
c
Unplug the power cord from the power supply jack on
the right side of the machine.
d
Raise the presser foot to remove the needle, presser
foot and presser foot holder.
• For details, refer to “Replacing the Needle” and
“Replacing the Presser Foot” in the “Basic
operations” section.
e
Remove the flat bed attachment if it is attached.
Chapter 1
MAINTENANCE AND
TROUBLESHOOTING
Care and Maintenance
To Next Page
Loading...
