BabySense PC01-CR - Regular and Sensitive Modes

in respect of the monitor, and all warranes, whether
express, implied or tacit, and any other liability from
whatsoever cause arising, are hereby expressly excluded
and the customer hereby indemnifies and holds harmless
Hisense in respect of such liability.
Note: when turning on the unit, all indicator lights are
turned on in an automated sequence and an audible
signal is heard.
• When turning on the unit, while the baery is low, 10
clicks will sound indicang that the baery needs to
be replaced.
• The Low Baery Indicator (red LED light 3) – flashes
when the baery requires replacement.
• The Alarm Indicator (red LED light, 4) – lights up when
no movement is detected , as described in secon
"Principle of Operaon" on page 6. The visual alarm
indicator is accompanied with an audible alert.
Regular mode
Turn the unit on by briefly pressing the ON / OFF buon
(1), and then fit your monitor properly to a diaper (see
"Fing your monitor" secon). Note: when turning on
the unit, all indicator lights are turned on in an
automated sequence and an audible signal is heard.
Sensive mode
Pressing and holding the ON/OFF buon for 5 (five)
seconds, will set the unit into a sensive mode,
accompanied with an addional unique sound. In this
mode, the sensor is set to pick up even slighter
movements than the regular mode.
10