BabySense PC01-CR - Replacing the Battery; Care and Maintenance

Fing on baby’s clothing (over the diaper):
Set the device to sensive mode as described in
"Sensive Mode" secon below.
Pete Clip Pete Clip can also be used clipped onto the
waistband of elascated pants and on a thin layer of
clothing separang the sensor from the skin, as long as
the movement sensor is snugly fied in the baby's
tummy area. Do not use too much or thick clothing as
this may reduce the sensivity of the monitor and
may muffle the alarm sound. Ensure the alarm can be
heard if baby is covered in clothing and/or blankets and
in all locaons throughout the place of care.
• The Performance Test must be conducted daily.
* In case the alarm does not sound, refer to the
Troubleshoong Guide.
Replacing the Baery
• Use only CR2 3V Lithium Baery
• To replace the baery, follow the instrucons on our
website: www.babysensellc.com/product/pete-clip
Care and Maintenance
Do not use force to bend the Monitor Clip and avoid applying
unnecessary pressure on the Sensor Pad (Fig.H and Fig.I).
Pete Clip requires no special treatment beyond replacing
the baery when the low baery indicator light illuminates.
Pete Clip is NOT waterproof. Do not immerse in water. You
may wipe the Pete Clip gently with damp cloth to remove
any dirt. Do not use any cleaning agents as they may contain
damaging chemicals.
Fig H
Fig I
13