5
G75-DFC - Differential Filtration Controller | IOM
IOM
General
• Prior to installation, operation, maintenance or any other type of action carried out on the G75-DFC Filtration
Controller, read the safety, installation and operation instructions carefully.
• The G75-DFC Filtration Controller operates as part of larger irrigation systems; therefore, it is essential to comply with
all the safety instructions and standards relevant to the whole irrigation system.
• During installation, operation, or maintenance of the controller all conventional, general and local safety instructions
should be observed in order to avoid danger to the workers, the public or to property in the vicinity.
• Always use personal safety gear such as gloves, full coverage clothes, helmet, and safety goggles.
• When installing or servicing the G75-DFC Filtration Controller, use only standard and adequate tools.
• The G75-DFC Filtration Controller must be used with non-hazardous liquids.
• The filtration battery controlled by the G75-DFC Filtration Controller enters to backwashing mode automatically
without warning.
• No change or modification to the equipment is permitted without a written notification given by Baccara Automation
& Control.
• Always observe standard safety instructions and good engineering practices whilst working in the filtration system
vicinity.
• Use the G75-DFC Filtration Controller only for its intended use, as designed by the manufacturer, any misuse of the
controller may lead to undesired damage and may affect your warranty coverage.
Preparation to Installation
• Shipping and transporting the G75-DFC Filtration Controller must be done in a safe manner and in accordance with
the relevant standards and regulations.
• Electrical wiring should be performed by an authorized electrician only, using standardized and approved
components and tools. Locate the G75-DFC Filtration Controller where direct water splashing on the electrical
components of the controller is avoided. Prevent electrification; when using an external power, appropriate external
fuse and wires gauge are required.
• Install the G75-DFC Filtration Controller where the filtration battery can be clearly seen from its installation point.
Installation
• Install the G75-DFC Filtration Controller according to the detailed Installation Instructions provided with it and
according to the description given in this manual.
• Leave enough clearance around the G75-DFC Filtration Controller for easy access for safe maintenance.
• Ensure easy and safe access to the G75-DFC Filtration Controller without climbing on pipes or equipment. Make
sure that any access equipment is built, installed and used in accordance with the relevant local regulations and
standards.
First Startup
• Carefully observe the First Start-up operation instructions prior to the first operation of the G75-DFC Filtration
Controller.
• For smooth operation and performance of the G75-DFC Filtration Controller, make sure to perform the startup and first
operation procedures exactly as described in this manual.
Operation and Maintenance:
• Do not operate the G75-DFC Filtration Controller before reading carefully and being familiar with its operation
instructions.
• Never operate or use the G75-DFC Filtration Controller for purposes other than its original design and operational
envelope.
• When servicing the G75-DFC Filtration Controller, disconnect it and the filters from the power supply.
• Before returning to regular operation follow the First-time Start-up Operation instructions as detailed in this user
manual.
SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
