Bachmann Dynamis Ultima User Manual

Servicetrack
- programs the locomotive(s) placed on the Service track
Place the loco on the section of track connected to the service track output
of Dynamis Ultima
MENU→PROGRAM→PROGRAMONSERVICETRACK[tick]
Enter the number of the CV you wish to program
Press VAL
Enter the value to be programmed to that CV
If necessary, add a programming method EDIT SERVICETRACK
Maintrack
- programs the selected locomotive running on the layout
MENU→PROGRAM→PROGRAMONMAINTRACK
How to write a value to a decoder
How to add service track programming methods
The default service track programming method (CV mode with power down) works for most decoders. If required by a
decoder other methods can be added from the system menu of the handset
MENU→SYSTEMMENU→EDITSRVTRKPROG
EDIT SRV TRK PROG SET SRV TRK PROG SCROLL: CV Powerdown
| Select Service Track programming methods to use
How to set STOP MODE
You can set the press of the STOP KEY to be either
POWER OFF - cuts power and all trains are stopped
(recommended for beginners)
ESTOP LOCOMOTIVE - controlled locomotive only is stopped. Hold
key down to cut power

Bachmann Dynamis Ultima Specifications

General

Brand	Bachmann
Model	Dynamis Ultima
Category	Remote Control
Language	English