5
1
Connect Screen Handle
A
and Mesh Screen
B
by using Nut
L
and Wrench.
Hardware Used:
L
Nut (M6) x 1 (pre-assembled on screen handle)
PREPARATION
Remove all parts from packaging and check to make sure you have all parts described in “Before You Begin” section on page 3.
Spread out parts on soft, level surface to avoid scratching parts.
2
Attach Leg
G
to Bottom Ring
F
by using Bolt
J
,
Washer
K
, and Nut
L
. Do not tighten them fully. Repeat
for remaining three legs. Attach Leg
G
to Uer Ring
E
by
using Bolt
I
and Washer
K
. Repeat for remaining three legs.
Tighten all bolts with scredrier.
Hardware Used:
I
Bolt (M6X15) x 8
J
Bolt (M6X30) x
K
Washer (M6) x 12
L
Nut (M6) x
1
2
G
J
E
L
K
I
K
F
A
A
L
B
To Next Page