Page 7
ASSEMBLY INSTRUCTIONS
4. Once the tank is attached to the regulator, make
sure the propane gas tank sits on the metal stand
inside body (B) completely. Turn the preassembled
wing screw on the outer part of metal stand
clockwise to secure the propane gas tank tightly.
5. Replace door (C) onto the body (B).
6. Remove the rubber cap on the electronic igniter (J)
by unscrewing and slide battery (H) into the battery
slot. Make sure the positive side of the battery faces
outwards. Screw the electronic igniter cap (J) over the
battery tightly.
B
B
C
J
H
To Next Page
Loading...
