7
INSTALLATION
1. Carefully unpack all items from the box. Place the base in the final position. There must
be a minimum of 24 in / 60.96 cm of clearance from the side of the table top to any
combustible walls.
2. Attach the back panel to the side panels by using four 1/4"x15 mm bolts and Ø6.5x1.0
mm washers as shown in Figure 2. Guide the bolts through the holes in back panel, into the
pre-drilled holes in the side panels. Hand tighten only.
Figure 2
3. Attach the middle support to the side panels by using two 1/4"x15 mm bolts and Ø6.5x1.0
mm washers as shown in Figure 3. Guide the bolts through the holes in the middle support,
into the pre-drilled holes in the side panels. Hand tighten only.
Figure 3
3. Attach the lp support to the side panels by using four 1/4"x30 mm bolts and Ø6.5x1.0 mm
washers as shown in Figure 4. Guide the bolts through the holes in the lp support, into the
pre-drilled holes in the side panels. Hand tighten only.
To Next Page