Operating Manual BaehrTec S2000
English– V101 – Status 07/2015 Page 25/52
The spray function is immediately switched on or off if you press the button (21) while the
handpiece motor is running.
The spray function is immediately switched on or remains switched off if you press the
button (21) when you switch on the handpiece motor while the handpiece motor is not
running.
This means that ready for use does not necessarily mean that the spray function is also
actually active, because the spray function is only active when the spray function is ready for
use and also
the handpiece motor is running.
Two additional symbols on the display indicate whether the spray function is actually active.
This symbol is shown when the spray function is not currently active at the
selected spray level (spray off).
This symbol is shown when the spray function is currently active at the
selected spray level (spray on)
(Can only appear while the handpiece motor is running).
Therefore, the following situations are possible:
Handpiece motor
Spray function
ready for use
Bar diagram
On the display
Spray
On Yes Filled blue On
This offers you the following advantage:
If you adjust the spray function so that it is "not ready for use" you can see
that last spray level you selected at any time. If you would now like to use
the same spray function level simply press (21) and the spray function is
As soon as you press one of the spray function buttons (22) - (27), (28) or
(29), this spray level is set and immediately "ready for use". This means
you only ever have to press one button.
To Next Page
Loading...
