Baehr Tec S2000 - Troubleshooting and Technical Data; Malfunction Self-Help

Operating Manual BaehrTec S2000
English– V101 – Status 07/2015 Page 45/52
5.10 Self-help in the event of malfunctions
Fault
Cause
Solution
Control device
without
function
• Main switch off
• Control device not
connected to power supply
• Connecting outlet without
power
• Mains cable not contacted
correctly (plugged in)
• Fuse(s) not correct (see
section "Change fuses)
• Turn on main switch
• Connect device to power
supply
• Connect the device to a
functional socket
• Plug device connector
correctly into the device
socket
• Check main fuse and
replace if necessary
The device must be
switched off and
disconnected from the
power supply before
checking the fuses.
Low or no
spray
and
handpiece
gets hot
• Fill level indicator ignored
• Fine filter in tank clogged
(see section "Care")
• Filling level contacts soiled
(see section "Care")
• Regularly check the filling
level indicator, fill up the
spray solution if necessary
• Change or clean fine filters
The device must
be switched off
and disconnected from
the power supply
beforehand!
• Cleaning filling level
contacts
Water leaks
from tank or
tank lid when
device upside
down (this is
usually the
case when the
device is
transported
and operated
from a case).
•
Lid is not closed properly.
• Liquid leaks from membrane
slit
• Liquid leaks between tank
lid and tank.
•
Screw lid on tight.
• incorrect spray solution
used.
Attention fire risk!
Membrane not positioned
correctly
• Check O-rings and replace
as required.