BAFANG DP C01.UART User Manual

8
DISPLAY MANUAL DP C01.UART
NORMAL OPERATION
• ON/OFF Switch
Press and hold the MODE button for power-
on. In the power-on status, press and hold
the MODE button for power-off.
Advice: If the electric bicycle is not used for
over four hours, please take the battery off
and store it properly.
• Switching of support level and assis-
tance mode
Switch the support level: press the + button
to raise the support level, or press the - but-
ton to reduce the support level.
Enter and exit the assistance mode: in the
power-on status, press the - button and hold
it for about three seconds to enter the walk
assistance mode; and release the button to
return to the ride mode.
Warning: the walk assistance mode applies
only when the rider is walking and pushing
the bicycle. Do not use the mode when
riding.
• Backlight On/Off
In the power-on status, press the + button
and hold it for two seconds to turn on
the backlight; and then press the - button
and hold it for two seconds to turn off the
backlight. If the bicycle is equipped with the
front/rear headlamps, the headlamps will be
on or off together with the backlight.
• Trip reset
In the power-on status, press the MODE and
- buttons at the same time for two seconds,
the single-trip distance will be reset.
The interface of single-trip distance indica-
tion is as below:
• Switching between single-trip distance
and total distance
In the power-on status, press the + button
to switch between single-trip distance and
total distance.
The interface of total distance indication is
as below:
• Battery capacity indication
The indication of remaining battery capacity
and corresponding capacity are shown in
the following figure:

BAFANG DP C01.UART Specifications

General

Brand	BAFANG
Model	DP C01.UART
Category	Monitor
Language	English