6
BF-UM-C-DP C07-EN November 2019
7.6.4 Headlights / backlighting
Hold (>2S) the button to activate the
headlight and the display backlight.
Hold (>2S) the
button again to turn
off the headlight and the display backlight.
The brightness of the backlight can be set
in the display settings "Brightness". (If the
display /Pedelec is switched on in a dark
environment, the display backlight/head-
light will automatically be switched on. If
the display backlight/headlight has been
manually switched off, the automatic sensor
function is deactivated. You can only turn
on the light manually after switching on the
system again.)
7.6.5 Walk Assistance
The Walk assistance can only be activated
with a standing pedelec.
Activation: Briefly press (<0.5S) the
button until to level null, and then press
(<0.5s) the button, the symbol is
displayed. Now hold down the button
and the Walk assistance will activate. The
symbol will flashes and the pedelec
moves approx. 4.5 km/h. After releasing the
button, the motor stops automatically and
switches back to level null (if no any option
be activated in 5 second). If no speed signal
is detected, it shows 2.5km/h.
7.6.6 Battery capacity indication
The battery capacity is showed in ten bars.
Each full bar represents a remaining capacity
of the battery in a percentage, if the frame
of indicator blinks that means to charge. (as
shown in the figure below):
Bars Charge in Percentage
10 ≥90%
9 80%≤C<90%
8 70%≤C<80%
7 60%≤C<70%
6 50%≤C<60%
5 40%≤C<50%
4 30%≤C<40%
3 20%≤C<30%
2 10%≤C<20%
1 5%≤C<10%
Blinking C≤5%
To Next Page
Loading...
Need help?
General
