BAFANG DP C07.UART - Normal Operation

J
Distance mode: display of the single-trip distance
TRIP and the total distance TOTAL
K
Battery level: 10-segment battery indication; the
voltage that each segment represents can be
customized
1.3.3 Key Definitions
A
up
B
down
C
headlight
D
on/off
E
mode
DISPLAY (DP C07.UART)
1.4 Normal Operation
1.4.1 On/Off Switch
Turn on the device. Press and hold for 2 seconds
to power on the display. Press and hold
again for
2 seconds to power off the display. If the bike is not
used, after 5 minutes (time can be set) the display will
be automatically turned off.
1.4.2 Assist Mode Selection
In the manual gearshift mode, press the
or
to choose the desired level of support by the motor.
The lowest level is Level 1, the highest Level 5. When
the display is on, the default mode is Level 1. When
there is no numeric mode display, there is no power
assistance.
Selecting the level for motor assistance
1.4.3 Switch between Distance Mode
and Speed Mode
to switch between distance and
speed. Single-trip distance ((TRIP km)
total distance
(TOTAL km)
maximum speed (MAXS km/h)
average riding speed (AVG km/h) are displayed in
successive order.
Switching between displays
Briefly press
CONSUMER MANUAL MAX DRIVE SYSTEM
CONSUMER MANUAL MAX DRIVE SYSTEM
10
11