14
2. Unlock the swiveling front wheels, swivel them to see the two
adjusting bolts in the front wheel, as pictured below.
3. If the cart veers left, use the 4mm Allen Key provided in the
Quad free spare parts to screw the right bolts (in both front
wheels) clockwise and/or the left bolts (as shown in the
picture below) counterclockwise.
4. If the cart veers right, use the 4mm Allen Key provided in the
Quad free spare parts to screw the right bolts (in both front
wheels) counterclockwise and/or the left bolts (as shown in
the picture below) clockwise.
Please note that there is a process in adjusting the track as
explained in points 3 and 4 above. It is suggested that the user
should make a small adjustment, test the tracking and then adjust
again until the cart goes straight. After the cart tracks straight, do
not swap the left and right front wheels.
6.3 Front Wheel Maintenance
During the life of the Quad cart, you may experience wearing of
the front wheel gasket. This may result in a noise coming from the
front wheel during use. You can replace this gasket at home using
1 of the 4 gaskets included in the spare parts included with your
cart. Follow these easy steps
Step 1: Remove the front wheel following the steps in section 6.1.
Step 2: Place the rubber gasket over the wheel pin.
Right BoltLeft Bolt
To Next Page