Bajaj Pulsar 150 CC DTS-i User Manual

CAUTION : Do not operate the starter
continuously for more than 5 seconds.
Wait for 15 seconds before next crank.
After three continuously cranking the
function will be disable after 20 seconds.
it can be unable again.
How to Ride Your Bike
12
NOTE : The motorcycle is equipped with a
starter lockout switch. The vehicle can start in
any gear when clutch lever is depressed.
It is recommended to start the engine with
the transmission in neutral.
Moving Off :
• Check that Center/Side stand is up.
• Depress the clutch lever.
st
• Shift into 1 gear.
• Open the throttle and release the clutch
lever slowly and simultaneously.
• As the clutch starts to engage, open the
throttle a little more, giving the engine just
enough rpm to keep it from stalling.
WARNING : When shifting down to
lower gear, do not shift at such a high
speed t hat the engine r pm rises
excessively & which may cause the rear
wheel to skid.
Gear Shifting Sequence
3
2
N
1
4
5
Gear Shifting Lever
Shifting Gears :
• Close throttle & depress the clutch.
• Shift into next higher or lower gear.
• Open the throttle and release the clutch
lever slowly and simultaneously.
How to Ride Your Bike
11
Running IN
Proper running-in is important for the better life
& trouble free performance of the vehicle.
• During first 2000 kms running-in period do
not exceed following speed limits.
Kms 1st 2nd 3rd 4th 5th
0 - 1000 15 30 45 55 65
1000 - 2000 20 40 55 65 75
• Always keep the speed below the limits
mentioned in the table.
• Do not race the engine excessively.
• Do not start moving or race the engine
immediately after starting. Run the engine
for a minute at idle speed to give the oil a
chance to work-up into the engine.
Riding the Bike
Before starting the vehicle & with the ignition
key ‘OFF’, adhere to the following first thing in
the morning or after a long period of non-use
(whichever is the case). Depress the clutch
lever completely. Kick the kick lever all the way
down to its stop, briskly a couple of times.
Release the clutch lever.
Starting the Engine :
• Keep the fuel tap to ON or RES position.
• Turn ignition switch to ON position.
• Turn Kill switch to ( ) ON position.
• Confirm that the vehicle (transmission) is in
neutral.
• If the engine is cold or when starting for
first time. Use choke for quick starting.
Choke lever (A) is located on LH side of
Carburettor.
• Keep the throttle completely closed, push
the starter button ( ) or kick the engine
with kick starter lever.
• When the engine is warmed up enough to
idle without using choke, return the choke
to OFF position.
A : Choke “OFF” B : Choke “ON”
A
B

Bajaj Pulsar 150 CC DTS-i Specifications

General

Brand	Bajaj
Model	Pulsar 150 CC DTS-i
Category	Motorcycle
Language	English