EasyManua.ls Logo

Bajaj Pulsar N160 - Braking, Stopping, and Parking

Bajaj Pulsar N160
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Warning: When shifting down to lower gear, do not shift at such
high speed that engine rpm jumps excessively. This may cause
engine damage, & rear wheel may skid. Downshifting should be
done at recommended speeds as shown in table above.
4. Braking & Stopping the Vehicle:
Close the throttle completely, leaving the clutch engaged
(except where shifting gears) so that the engine braking will
help slow down the motorcycle.
Shift down one gear at a time so that you are in Neutral when
you come to a complete stop.
When stopping, always apply both brakes at the same time.
5. Parking Using Side Stand:
Support the motorcycle on a firm level surface with the side
stand.
Lock the steering on LHS.
Caution: Do not park on a soft or steeply inclined surface as the
motorcycle may fall over.
17 km/h
33 km/h
45 km/h
57 km/h

Related product manuals