Document: 333D012G
5-18-2007
- 44 -
Getting the unit off the pallet
1) To protect the floor finish, use a moving blanket. Carefully slide the unit off the pallet onto the
moving blanket.
2) Slide the unit into its destination room before going further with the assembly/installation.
Installing the Adjustable Leg Leveler or Caster Option
3) Lift one end of the unit / stand assembly up a minimum of 7” [178mm] and block in position. See
illustration below.
4) Screw in two of the Adjustable Leg Leveler or Castors (Item# 1). Screw in by hand as tight as you
can then remove the blocking.
1
To Next Page
Loading...
