389D001 Rev G 10 of 94
1. Channel Stand Assembly Procedure:
Step 1:
Remove stand components from rear of
cabinet skid if shipped as shown.
Remove items 4-11 from the separate
box shipped with the cabinet.
If cabinet is factory shipped on channel
stand please see channels stand leg
assembly procedure
Step 2:
Gather all stand components, hardware, and tools.
Step 3:
Place stand sides on a flat floor surface.
Place the stand back between the sides
so that the open part of the channel is
facing down towards the floor. Place
the braces
as shown.
Step 4:
Using the
3
/
8
”x 1” hex head bolt with
lock and flat washers [Items 5, 7, & 8],
attach the sides and back by inserting
the bolts thru the (4) holes located in
the channel stand back into the already
installed rivnuts in the two sides. (2)
bolts per side. Do not tighten any of
these bolts until you have all (4)
threaded in slightly. Tighten bolts after
this is done.
Channel stand
brace
Channel stand
side
Channel stand,
brace
3
/
8
” Hardware
Flip the stand 90º to
access lower hole
Channel stand
gusset
To Next Page
Loading...
