Baker SterilGARD SG604-INT - Channel Stand Installation Procedure

389D001 Rev G 9 of 94
Channel Stand Installation Procedure
Document: 389D002 Rev A
Release Date: 03/24/14
This procedure describes the proper assembly of the SGX04 basic channel stand and the correct installation
underneath the cabinet. It provides step by step instructions for the channel stand installation in two instances:
1. The Channel Stand Assembly Procedure when the stand ships from the factory separately from the
cabinet
2. The Channel Stand Leg Assembly Procedure when the channels stand is factory attached to the
bottom of the cabinet
Tools required:
7
/
16
” deep socket,
9
/
16
” wrench or socket, level
Parts List:
Item Number
Part Number
Description
Qty
1 389W401/390W401/365W401 Channel stand, brace 1
2 390W410 Channel stand, side 2
3 389P401 Channel stand, gusset 2
4 40273 Bolt, carriage,¼”-20 x 2” long 4
5 10392 Bolt, hex head,
3
/
8
”-16 x 1” long 24
6 11283 Flat washer, ¼” 4
7 11286 Flat washer,
3
/
8
” 24
8 11311 Lock washer,
3
/
8
” 24
9 10512 Hex lock nut, ¼” 4
10
390P406 with 43312
(390P416 with 43345/43346)
Adjustable leg with leg leveler (or
optional castor)
4
11 390P414 Channel , cover 4
12 11776 Plug, leg 8
NOTE: Caster stand option requires four modified leg assemblies (Not shown).