B&B Electronics ESP901 - Appendix C: Rs-485 Connections; Serial Server DB-9 Pin-Out in RS-485 Mode

RS-485 Connections
Manual Documentation Number: ESP901-902_5012m Appendix C 79
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Pk – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
A
A
P
P
P
P
E
E
N
N
D
D
I
I
X
X
C
C
:
:
R
R
S
S
-
-
4
4
8
8
5
5
C
C
O
O
N
N
N
N
E
E
C
C
T
T
I
I
O
O
N
N
S
S
Serial Server DB-9 Pin-out in RS-485 Mode
RS-485
Signal Name
Direction
RS-485
DB9M
Pin
Data B (+)
In/Out
DATA B (+)
3
Data A (−)
In/Out
DATA A (−)
4
Signal Ground
---
GND
5
Figure 70. DB-9 Pin-out in RS-485 Mode
N
N
o
o
t
t
e
e
:
:
Some RS-485 devices are marked opposite the RS-485 standard,
which defines the Data B line as positive relative to Data A during a
Mark state before enabling the transmitter, and after transmitting
before tri-stating. If an RS-485 device does not respond, try swapping
the Data B and Data A lines.
Figure 71. 2-wire RS-485 Connection
To connect 4-Wire RS-485 devices, the RS-422 Mode can be used
provided the Serial Server will be connected as a master in a single
master system. If using multiple masters, the Serial Server cannot be
used, as it does not tri-state the transmitter in RS-422 mode.