B&G HERCULES Installation Guide

HERCULES
®
and HERCULES
®
WTP
INSTALLATION GUIDE
Parts included
A
B
C
D
E
F
G
H
B&G
Scan to register your sailing processor
using the B&G app
A Hercules
®
or Hercules
®
WTP sailing processor
B Mounting screws (PH2, 19.05 mm / 0.75 in)
C Connector pack
D Power cable (3 m / 9.8 ft)
E NMEA2000
®
cable (1.2 m / 4 ft)
F NMEA2000
®
connector
G Ethernet cable (3 m / 9.8 ft)
H Registration details card
Mounting
Hercules
®
and Hercules
®
WTP sailing processors can be mounted
vertically or horizontally.
To prevent interference between the unit and the vessel’s
compass(es), ensure the unit is at least 50cm(20 in) away from
any compass.
Mark the hole positions and drill pilot holes.
Use a #2 Phillips head screwdriver to secure the sailing processor
with the four supplied screws.
⚠ CAUTION: Always wear appropriate eyewear, ear protection
and dust mask when drilling, cutting, or sanding.
Remember to check the reverse side of all surfaces whenever
drilling or cutting.
*988-13087-001*

B&G HERCULES Specifications

General

Brand	B&G
Model	HERCULES
Category	Lighting Equipment
Language	English