Bandit 2590 - Page 19

Bandit
17Copyright 6/18
MODEL 2590
LOCATION NUMBER DESCRIPTION
42. N-02 Maintain Lubrication...
43. N-03 Service Required Under Beltshield...
44. N-05 Frequently Adjust...PTO...
45. SPN-06 Decal Maintenance...
46. N-07 Clutch Operation...
47. N-09 Adjustable Feed Speed...
48. SPN-11 Correct Knife And Hardware...
49. SPN-14 Do Not Start To Weld...Unless...
50. SPN-16 24 Volt Circuit
51. SPN-17 Battery Disconnect Switch O󰀨 (Arrow) On
52. SPN-20 Maximum Towing Speed 55 MPH (88 KPH)
53. N-30 Wait 2 minutes to disconnect battery
54. SPN-36 12 Volt Circuit
55. N-30 Must Wait 2...Before Turning O󰀨 Battery...
56. N-51 Battery Instructions
57. N-69 Patents....
58. SPW-01 Do Not Go Near Oil Leaks...
59. SPW-02 Diesel Fuel Only...
60. SPW-04 Frozen Battery Can Explode...
61. SPW-06 Warning Side Slope
62. SPW-07 Warning Sound Horn
63. SPW-08 Wear Personal Protection...
64. SPW-11 Warning Parking on Slope
65. SPW-13 Warning Clean Debris
66. SPW-15 Warning Belt Shield Door
67. SPW-27 ...Equipment May Create Sparks...
68. SPW-31 Explosion Hazard...Ultra Low Sulfur Diesel...
69. 900-8901-14 Basic Safety Decal Kit (Options may require additional decals)
70. 900-8900-56 Bandit Model 2590 Logo Decal Kit
Additional Decals for Machine Equipped With A Track Undercarriage - Consult dealer or manufacturer
for general locations.
71. SPD-19 ...Minimum 10 Feet Away From Tracks...
72. SPD-38 Do Not Entangle Feet...
73. SPW-06 Do Not Attempt...Slope Of More Than...
74. SPW-07 Do Not Move Machine...Horn Is Blown...
75. SPW-11 Do Not Leave Unit Parked On A Slope...
Some decals are for optional equipment. Decal locations may vary, these are general locations.
If any decals become damaged, replace immediately.
DECALS
DECAL LOCATIONS - 2590
NOTICE
Modications and/or additions of decals to this list will happen.
Consult chipper dealer or manufacturer for most current decal package.