Bandit 2590 - Page 37

Bandit
33Copyright 6/18
MODEL 2590 CONTROLS
STABILIZERS - FIFTH WHEEL HITCH
Front Stabilizer Control Valve:
NOTE: Remove the lock pin BEFORE operating this function.
The front stabilizer control valve operates the front stabilizer cylinder. (there will be one valve on each side)
To raise the front of the machine, push the control handle away from you, towards the machine. To lower the
front of the machine, pull the control handle towards you, away from the machine. The stabilizer control valve
is the o󰀨 position in the center position.
Rear Stabilizer Control Valve:
NOTE: Remove the lock pin BEFORE operating this function.
The rear stabilizer control valve operates the rear stabilizer cylinder, there will be one valve on each side
of the machine near the rear stabilizer. To lower the rear stabilizer, push the control handle away from you,
towards the machine. To lift the rear stabilizer, pull the control handle towards you, away from the machine.
The rear stabilizer control valve is in the o󰀨 position in the center position.
900-3920-01
900-3920-01