Bandit 2590 - Page 52

Bandit
48
Copyright 6/18
MODEL 2590
Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Lubrication & Coolant
Section and Maintenance Section of this manual, or component manufacturer’s manual.
NOTICE
LUBRICATION CHART
7
4
10
9
A right angle grease tting may need to be used to grease some of the lubrication
points. This type of grease tting can be obtained from most local automotive
parts stores.
14
MAINTENANCE
CHECK
# DESCRIPTION DAY WEEK MONTH PROCEDURE
1 Drum Bearings X 16 pumps monthly - wipe o󰀨 excess
2 Feedwheel Bearings X 1 shot of grease - wipe o󰀨 excess
3 Infeed Conveyor Bearings X 1 shot of grease - wipe o󰀨 excess
4 Hood Hinge X 1 to 2 shots of grease - wipe o󰀨 excess
5 Discharge Flipper X Daily - wipe o󰀨 excess
6
Steel Friction Areas: pivoting,
hinged, sliding, rolling
X
Lubricate (i.e. yoke lock pins, cabinet doors,
radiator screen hinges, etc.)
7 Pintle Eye Ring / Towing Hitch X Grease to reduce wear
8 Infeed Chain Adjuster X 2 to 3 shots of grease - wipe o󰀨 excess
9 Chain Driven Components X Dry lube (chain driven feedwheels)
10 Pump Bearing Block Keep Full Change every 6 mo. 80W/90 Lube & Grease splines
11 Bottom Feedwheel Gearbox Keep Full Change every 6 mo. 80W/90 type gear lube
12 Feedwheel Slide Box X Clean and oil with 10W/30
13 Wheel Beaings - if applicable Lubricate per MFG’s instructions
14 Clutch Lubricate per MFG’s instructions