Bandit 2590 - Page 83

Bandit
79Copyright 6/18
MODEL 2590
CORRECTING HYDRAULIC PROBLEMS
When returning hydraulic components for warranty make sure to box up all warranted parts to avoid additional
damage while shipping. Do not disassemble any hydraulic components which are to be warranted.
Anything which has been disassembled or tampered with will not be warranted. Items being returned must
be clean. All hydraulic components must have all hosing ports plugged. Failure to plug ports will allow debris
to enter components which will void warranty.
NOTICE
COMPONENT
Checking relief
valve setting
Adjusting relief
valve setting
Cleaning relief
valve (with engine
shut o󰀨)
Checking for
defective pump
Checking for
defective motor
PROCEDURE
Contact your nearest dealer or Bandit Industries for instructions to check the
relief valve setting.
Contact your nearest dealer or Bandit Industries for instructions to adjust the
relief valve setting.
Contact your nearest dealer or Bandit Industries for instructions to clean the
relief valve.
1. See pages 82 - 83 on how to check a hydraulic pump.
1. If everything checks out as correct, it may be time to check the
hydraulic motor.
2. If your machine has Live Hydraulics, see page 81 on how to check a
hydraulic motor.
3. If your machine does not have Live Hydraulics, contact your local dealer or
Bandit Industries for instructions.
MAINTAIN FEEDWHEEL HYDRAULIC PRESSURE AT SPECIFIED PSI (bar)
Follow typical hydraulic ow and relief settings on page 75.
Follow proper hydraulic oil requirements on pages 73 - 74.
Before attempting any type of maintenance disengage clutch, wait for the disc/drum to come to a complete
stop, turn o󰀨 engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, and disconnect the battery.
HYDRAULICS