13258 11/01
From Remote From Front Panel Action
1
(PAUSE) or
V
(STOP)
(UP) or
(DOWN) move to Zone 2 Setup (B)
2
SEL or ENTER
↵
(ENTER)
activate ADVANCED ZONE B SETTINGS
Zone 2 (B) Level Control -
You may wish to install an in-wall volume control in your second zone. This can
cause confusion between your processor’s internal Zone 2 (B) volume controls and your in-wall controls.
WARNING - Setting Zone 2 (B) LEVEL CONTROL to FIXED will cause your processor to immediately send
its maximum Zone 2 (B) volume to your second zone (if Zone 2 (B) is on). Turn down your in-wall volume
controls before making this change.
From Remote From Front Panel Action
1
(PAUSE) or
V
(STOP)
(UP) or
(DOWN) move to Level Control
2
X
(REW) or
W
(FF)
VOLUME KNOB adjust level to desired value
Zone 2 (B) Max (Fixed or Variable) Level -
Z2 max level allows you to set a maximum volume level for Zone 2
(B). This is very useful if you are using speakers that can’t handle the maximum power output from your external
amplifier or if you simply wish to limit the volume that can be achieved using normal front panel or remote
operation. If you have chosen Zone 2 (B) level control (fixed), then this setting becomes the fixed level for Zone 2
(B). If you have chosen Zone 2 (B) level control (variable) then this setting allows the level for Zone 2 (B) to be
adjusted. However, when adjusting this level it cannot exceed the value set in Zone 2 (B) max level.
WARNING - If you set this level too low, the processor may appear broken (no sound).
From Remote From Front Panel Action
1
(PAUSE) or
V
(STOP)
(UP) or
(DOWN) move to Fixed Level
2
X
(REW) or
W
(FF)
VOLUME KNOB adjust level to desired value
5 Link Input to Zone A No
6 Link Power to Zone A No
=% /9/ 9$5,$%/(
5 Link Input to Zone A No
6 Link Power to Zone A No
=% /9/ ),;('
5 Link Input to Zone A No
6 Link Power to Zone A No
=% 0$; /(9(/
5 Link Input to Zone A No
6 Link Power to Zone A No
=% ),; /(9(/
To Next Page
Loading...
Need help?
General
