b&t RTL8720D - ATPM-Modify MAC Address; 4 TCP;UDP Commands; ATPS-Create a TCP;UDP;SSL Server

中山市博安通通信技术有限公司
ZHONGSHAN B&T TECHNOLOGYCo., Ltd
Page 13 of 34
[ATPG] OK
3.11 ATPM-modify MAC address
ATPM=<mac>
Description
Modify MAC address
Response
Success
[ATPM] OK
Fail
[ATPM] ERROR:<error_no>
Parameter
mac:6-byte hex number
Error
Code
1: The Command format error.
2: Parameter error
Note
After the MAC is set successfully, it needs to be restarted to take effect.
Example
# ATPM=aa2233cc55ff
[ATPM] OK
3.12
ATWQ simple config Network configuration
ATWQ
Depai
nt
Simple config distribution network
For more information about apps and references, see
SDK/tools/simple_config_wizard_3.4b"
Resp
onse
[ATWQ] OK
The input will not be returned immediately, and will not be returned until the network
configuration succeeds or fails. Other messages need to be viewed in the log port.
4. TCP/UDP commands
4.1
ATPS-create a TCP/UDP/SSL Server
ATPS =<mode>,<Local Port>
Description
Create TCP/UDP/SSL server
Response
Success
[ATPS] OK
[ATPS] con_id=x (x=[1,9],
con_id 0 is reserved)
In TCP mode, this parameter is