NanoRam
®
Series Handheld Raman
19 Shea Way, Newark, DE 19713, USA • Tel: +1 (302) 368-7824 • Fax: +1 (302) 368-7830 • Web: www.bwtek.com
290020255-J (2017/07/28) Page 23 of 38 Copyright 2017 B&W Tek
The laser can be turned on only when the system is in Identification, Investigation, or
Library and Method building modes. Pressing the laser button, or Home button during a
scan can stop an acquisition. If such an action occurs, the data may not be saved.
Note: In case of emergency, the laser can be turned off any time by pressing the Laser
switch button or Home button.
3. Operator User Quick Start
3.1. User Login
The following instructions assume that an Operator account has already been set up by
the Administrator.
At the user login screen, enter the user name and password and then press Login. The
home screen for basic user will be displayed. The user information including user name
and user type will be displayed on the upper left of the screen.
The user can select Remember User Name to automatically recall the user name. Only
the last user name can be remembered. The password is always needed for login
attempts.
When the wrong user account information is entered, the system will allow three trials
before the system locks out the user. After the system is locked out, the user will be
prompted to turn off the system and try again with the correct account information:
“You are not authorized to access this device. The device has been temporarily
locked. Please verify your login info and try again at the next power up.”
To Next Page
Loading...
Need help?
General