Banner QS30LLPQ - SETUP Mode Operations; Accessing and Selecting Options

SETUP Mode
SETUP mode is accomplished via the sensor’s two push buttons.
It is used to change sensor output response for:
• Light or Dark Operate
• 30-millisecond pulse stretcher (OFF-delay), if required.
The status LEDs, active only during SETUP mode, indicate the
output response configuration when the sensor will be in RUN
mode.
11
33
44
5
6
7
8
22
LO
DO
+
GAIN
—
SETUP
status
indicators
Figure 5. SETUP Mode
Push Button
0.04 seconds
< T < 0.8 seconds
Result
Access SETUP
Mode
• Press and hold both push but-
tons > 2 seconds
• Green Power LED turns OFF
+
—
GAIN
Select SETUP
Options
• Click either push button to toggle
through the four possible setting
combinations.
or
+
—
DO, No Delay
+
—
DO 30 ms Delay
+
—
LO, 30 ms Delay
+
—
LO, No Delay
Return to RUN
Mode
• Press and hold both push but-
tons > 2 seconds
• Green Power LED turns ON
+
—
GAINGAIN
WORLD-BEAM QS30 LLP and LLPC
6 www.bannerengineering.com - tel: 763-544-3164 P/N 112355 Rev. C