What to do if the distance being taught is outside of the valid sensing range for Banner Q4X?
If the distance being taught to your Banner Accessories is outside of the valid sensing range, present a target within the sensor's specified range and then re-TEACH the device.
What to do if Banner Q4X output is short-circuited?
If the output of your Banner Accessories appears to be short-circuited, the first step is to carefully check the wiring. Look for any electrical short circuits and make sure that the wiring is correctly configured.
What to do if Banner Q4X Accessories signal is saturated?
If the signal of your Banner Accessories is saturated due to too much light, try repositioning either the sensor or the target. Another approach is to increase the angle of incidence between the sensor and the target to reduce the amount of light received.
What to do if Banner Accessories shows no valid signal in range?
If your Banner Accessories unit is showing 'no valid signal in range', attempt to reposition the sensor or the target.
What to do if the adjusted endpoint is between the other endpoint and the end of range in Banner Q4X Accessories?
If the adjusted or taught end point in your Banner Accessories is between the other end point and the end of range, resulting in insufficient space to create the minimum window size, you should TEACH or adjust the end points to maintain the minimum window size within the sensing range.
What to do if there is a signal saturated (too much light) in Banner Q4X Accessories?
If the signal is saturated (too much light) in Banner Accessories, reposition the sensor or the target to increase the detection distance, or increase the angle of incidence between the sensor and the target.
What to do if Banner Q4X has no valid signal in range?
If Banner Accessories has no valid signal in range, reposition the sensor or the target.
What to do if the adjusted or taught end point is between the other end point and the end of range in Banner Q4X Accessories?
If the adjusted or taught end point is between the other end point and the end of range in Banner Accessories, TEACH or adjust the end points to maintain the minimum window size within the sensing range.
What to do if the adjusted or taught window size is smaller than the minimum window size in Banner Q4X Accessories?
If the adjusted or taught window size is smaller than the minimum window size in Banner Accessories, the sensor automatically adjusts the window size to maintain the minimum window and completes the adjustment or the TEACH.
General| Supply Voltage | 10-30 VDC |
|---|---|
| Housing | Stainless steel |
| IP Rating | IP69K |
| Operating Voltage | 10-30 VDC |
| Protection Rating | IP69K |
| Housing Material | Stainless steel |
| Connection Type | M12 connector |
| Sensing Mode | Diffuse |
To Next Page