(SELECT)(TEACH)
• Press and hold for longer than 2 seconds to start the
currently selected TEACH mode (the default is two-
point TEACH)
• Press to select menu items in Setup mode
(-)(MODE)
• Press to change the distance setting for the 0 V (4
mA ) point; press and hold to decrease numeric
values
•
Press and hold for longer than 2 seconds to enter
Setup mode
• Press to navigate the sensor menu in Setup mode
(+)(DISP)
• Press to change the distance setting for the 10 V (20
mA) point; press and hold to increase numeric values
• Press and hold for longer than 2 seconds to toggle
the display value between the distance and the
analog output
• Press to navigate the sensor menu in Setup mode
Note: When navigating the menu, the
menu items loop.
1.4 Laser Description and Safety Information
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. Do not attempt to disassemble this sensor for
repair. A defective unit must be returned to the manufacturer.
≤ 510 mm Models - IEC 60825-1:2007 Class 1 Laser
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
Laser wavelength: 655 nm Output: < 0.20 mW Pulse Duration: 7 µs to 2 ms
> 510 mm Models - IEC 60825-1:2014 Class 1 Laser
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
COMPLIES WITH IEC 60825-1:2014
CLASS 1
LASER PRODUCT
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR CONFORMANCE WITH
LASER NOTICE No. 56, DATED MAY 8, 2019.
IEC 60825-1:2014, AS DESCRIBED IN
BANNER ENGINEERING CORP.
9714 10TH AVENUE NORTH
MINNEAPOLIS, MN 55441
Laser wavelength: 655 nm Output: < 0.39 mW Pulse Duration: 7 µs to 2 ms
Q4X Stainless Steel Analog Laser Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 5
To Next Page
Loading...
