• Switches the meter On/Off.
• Exits the calibration or setting and returns to the measurement screen.
• Starts calibration.
• Enters the setup menu (Press and hold the key for 3 seconds).
• Stores current reading to memory.
• Increase value or scroll up through the menu item.
• Views the data log.
• Decrease value or scroll down through the menu item.
• Confirms the calibration, settings or displayed options.
• Starts measurement.
• Locks the measured value.
Switching the Meter On and Off
• Insert the connector of power adapter into the power socket on the rear panel of the meter.
• Press and release the key to switch on the meter.
• Press and hold the key for 3 seconds to switch off the meter.
Prior to Use
Switch on the meter and allow the meter to warm up for at least 15 minutes.
1. Light shield lid
2. Measurement chamber
3. TFT display
4. Membrane keypad
5. Power socket
6. USB interface
To Next Page
Loading...
