Level 1 men
Set
Level 2 menu
Radio set
Level 3 menu
Language
ANI SW
DTMF side tone
Scan resume
PTT-ID
PTT-LT
TX-A/B
Options
English
Chinese
ON
OFF
OFF
ON
TO
co
SE
OFF
BOT
EOT
BOTH
100-1000ms
Main Ch
RX Ch
Description of settings
English version, including menu, call tips, call logs and all
other interfaces
Simplified Chinese
When ANI (DTMF caller 'D) is tumed on, the caller ID is
displayed when there is an incoming call
OFF
When DTMF digits are sent, the unit does not make sound
When DTMF digits are sent, the unit audibly sounds
Time mode scan; resume scanning in 5 seconds after signal
is first found
Carrier mode scan; wait for 5 seconds after the carrier
disappears before resuming scanning
Search mode scan; halt scanning after signal is found
Do not send code when PTT is pressed
Radio DTMF ID is sent at the beginning of transmission; ID
can be set by the computer configuration software
Radio DTMF ID is sent at the end of each transmission; ID
can be set by the computer configuration software
Send ID when PTT is first pressed and when released
The delay time before automatic transmission
Determines whether the main channel or channel being
received is the channel that is active for PTT in double wait
mode.
Remark
For analog
mode only
To Next Page
Loading...
