All Call
All call is that a single two-way radio calls all two-way radios on
the channel. It is widely used to publish important notices that
require special attention from users
Initiate an All-Call
There are two ways to initiate all call: Initiate a call to an All-call
preset if it is programmed as your default contact for the digital
channel; or through the "Contact list". The specific method is
same as "initiate group call "described above.
Note:
You can initiate all call only when the dealer has enabled
this function.
You can't reply to the received all call.
After receiving all call, if you switch to another channel, the
radio stops receiving all call. During all call, you can't use the
preprogrammed button until the call ends.
Analog Channel Call
To transmit on the analog channel, press and hold the [PTT]
button and speak to the microphone. To receive, release the
[PTT] button
DTMF Call
Initiate a Call:
In analog mode, press and hold the [PTT] button and press
the number buttons on the panel.
Press the [MENU] button to select a contact, and press the
[PTT] button to start DTMF call.
Receive a Call
If the channel has been configured by computer to have DTMF
signaling mute, any calls will only be heard if the DTMF code
word matches the personal ID code. You can make call with the
other party in the reset time and the code word should be re-
decoded when the reset time is up.
PTT ID Call
Initiate a Call
In analog mode, you can configure the DTMF online code and
offline code through host computer and enable online code and
offline code for analog channel, or set by (MENU Set —9Radio
Set —9PTT D). When the online code is enabled, the DTMF
code is sent when you first press the [PTT] button, and the
offline code is sent when the [PTT] button is released.
To Next Page
Loading...
