R5910551 /00 Eonis10
2.1 Cable connections
To connect the cables
1. Connect one or more video source(s) to the corresponding video inputs. Use the appropriate video cable
(s) to do this.
The input source to be displayed can be selected in the OSD menu (see “Input source selection”, page 15).
Image 2-1
2. Connect the USB upstream connector to a PC USB host to make use of QAWeb or any of the display USB
downstream connectors (e.g. to connect a keyboard, mouse or other peripheral).
Image 2-2
3. Connect the mains power input to a grounded power outlet.
Image 2-3
4. If necessary for your application, earth the MDRC-2321 by connecting the earth pin to a grounded outlet by
means of a yellow/green AWG18 wire (maximum admitted cable length according to national regulation
requirements).
Installation
To Next Page
Loading...
