How to fix a Barco G62 Projector when no image appears on the screen?
If your Barco Projector shows no image, first ensure all cables and the AC power are correctly connected. Also, check the connectors for any bent or broken pins. Finally, make sure the “Shutter (AV Mute)” function is disabled.
How to make the image sharper on my Barco G62 Projector?
If the image displayed by your Barco Projector is fuzzy and blurry, try pressing the “Focus ?” or “Focus ?” button on the remote control or control panel to adjust the image until it is sharp and clear. Also, ensure the projection screen is at the correct distance from the projector.
How to adjust the image size on a Barco G62?
If the image from your Barco Projector is too small or too large, you can adjust the image size by pressing the “Zoom ?” or “Zoom ?” button on the remote control or control panel, or by selecting “Installation > Lens > Zoom“ from the OSD menu. You can also adjust the distance between the projector and the screen, or modify the aspect ratio by selecting “Installation > Aspect Ratio“ from the OSD menu.
What to do if my Barco Projector remote control is not working?
If your Barco Projector's remote control isn't working, first check that you are pointing it within ±30° (front and back) of the remote receivers on the projector. Next, inspect the remote's batteries, ensuring they are correctly inserted and not depleted. Lastly, verify that you have set the correct IR code on the remote control.
Why is my Barco G62 Projector image partial or scrolling?
If your Barco Projector displays a partial, scrolling, or incorrectly displayed image, try pressing “Auto” on the remote control to automatically detect the input signal. If you are using a PC or Notebook, set the resolution to WUXGA (1920 × 1200) or lower. If using a Notebook, ensure you press the appropriate keys to send the signal to the projector. If you still have difficulty, restart all equipment, including the projector.
How to correct keystone on a Barco Projector?
If the image on your Barco Projector is not an even rectangle, perform keystone correction by pressing the “Keystone H“ and “Keystone V“ buttons on the remote control, or by navigating to “Installation > Geometry Correction > Basic Warp > Keystone Horizontal or Vertical” in the OSD menu.
Why is my Barco G62 image stretched with 16:10 DVD videos?
If the image displayed on your Barco Projector is stretched when displaying 16:10 DVD videos, set the appropriate aspect ratio for the projector by selecting “Installation > Aspect Ratio“ from the OSD menu. Also, set the aspect ratio to 16:10 on the DVD player itself.
How to reverse the image on a Barco Projector?
If the image on your Barco Projector is reversed, enable rear projection by selecting “Installation > Orientation > Direction > Rear Projection” from the OSD menu.
What to do if my Barco Projector stops responding?
If your Barco Projector stops responding to all controls, try turning it off, unplugging the power cord, waiting at least 60 seconds, and then reconnecting the power.
General| Contrast Ratio | 2000:1 |
|---|---|
| Technology | DLP |
| Throw Ratio | 1.5 - 2.0:1 |
| Resolution | 1920 x 1200 |
| Brightness | 6000 lumens |
| Light Source | Lamp |
| Lamp Life | 3000 hours |
| Input Connectors | HDMI, DVI, VGA |
| Power Consumption | 450 W |
To Next Page
